
We rebuild fireboxes, reline flues, and stop chimney leaks for good.
Fireplace Restoration in Orange, New Jersey, Done Right
Fireplace restoration in Orange, New Jersey means tearing out cracked firebrick, relining the flue, and sealing the chimney so it drafts clean and holds heat. We handle 1920s brick fireplaces in Old Towne Orange and modern inserts alike. If your fireplace smokes, smells, or crumbles, we fix the cause, not the symptom. Same-day estimates, code-correct work, and a written warranty on every job.
What's included
What Is Included in Fireplace Restoration
A full restoration covers the firebox, flue, damper, crown, flashing, and waterproofing. We sweep and burn-test at the end. Cosmetic work like a new hearth or mantel is quoted separately. Here is the breakdown.
Firebox Rebuild
We cut out cracked and spalled firebrick, then rebuild with new firebrick and refractory mortar. Joints are struck with a mortar jointer for a clean finish. This restores the firebox to a safe, heat-rated surface.
Flue Relining
A stainless steel liner sized to your firebox is installed and insulated with ceramic fiber. It connects to the damper and cap. This is what restores safe draft and keeps carbon monoxide out of the house.
Damper Repair or Replacement
A rusty or seized damper gets repaired or replaced. We make sure it seals tight when closed and opens fully when you light a fire. It is a small part that makes a big difference in heat loss.
Crown Rebuild
We remove the failed crown, rebuild it with chimney crown mix, and slope it to shed water. A sound crown is the single best defense against chimney leaks and freeze-thaw damage.
Flashing Reset and Waterproofing
Flashing at the roof line is reset or replaced and sealed. We finish with a waterproofing sealant on the brick. Together these stop water intrusion at the two most common entry points.
Sweep and Burn Test
We sweep the flue with chimney brushes and rods, remove the debris, and build a test fire. You watch the draft and see for yourself that it burns clean. Photos of the before and after are included.
Service overview
What Fireplace Restoration in Orange, New Jersey Covers
Fireplace restoration in Orange, New Jersey is the structural and code-correct rebuild of a fireplace and its chimney system that has cracked, spalled, or stopped drafting. It goes past sweeping: we cut out failed firebrick, repoint mortar joints with refractory mortar, reline the flue with a stainless steel liner or clay flue tile, rebuild the crown, and reset the damper so the firebox pulls air the way it was engineered to. A restoration is needed when heat, water, or age has compromised the masonry or the flue, not just when the chimney looks dirty.
Most Orange homes we open up are 80 to 120 years old, and the chimneys show it. Water gets into the crown, freezes, and pops the brick face off. Creosote builds up behind a rusty damper. A flue liner deteriorates until carbon monoxide can seep into living space. If you have been searching for fireplace restoration in Orange New Jersey near me and keep finding sweep-only companies, that is the gap we fill. We rebuild the whole assembly so it is safe to burn again.
The service timeline
Our Fireplace Restoration Process, Step by Step
The process flexes to the condition, but these checkpoints keep decisions clear.
Inspection
We run an inspection camera up the flue and photograph the firebox, damper, crown, and flashing. You see the same images we do. This takes 45 to 60 minutes and tells us whether you need a reline, a rebuild, or both. We check the flue liner for gaps, the mortar joints for failure, and the smoke chamber for creosote glaze.
Written Scope
You get a fixed price with line items: liner, firebrick, crown, damper, labor. No hourly surprises. We note what is urgent and what can wait a season. If the crown is fine and only the damper is seized, we tell you that instead of selling a full rebuild. Upfront pricing, one page, signed before we start.
Teardown and Rebuild
We lay drop cloths, cut out failed firebrick with an angle grinder and diamond blade, and remove deteriorated flue tile. New firebrick goes in with refractory mortar, joints struck with a mortar jointer. Most firebox rebuilds take two to three days. We keep the work area sealed so dust stays out of the house.
Relining and Sealing
We install a stainless steel liner sized to the flue, insulate it with ceramic fiber insulation, and connect it to the damper and cap. The crown gets rebuilt with chimney crown mix, flashing is reset, and we apply waterproofing sealant. This is the step that stops chimney leaks and restores draft. One to two days.
Burn Test and Walkthrough
We build a test fire, watch the draft, and check for smoke spillage at the firebox. You get photos of the before and after, the liner warranty paperwork, and a maintenance schedule. Total job time runs three to five days for a full restoration. We do not leave until it burns clean.
Tools & methods
Tools and Methods We Use
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Inspection Camera
Goes up the flue to photograph cracks, gaps, and creosote glaze. You see the footage before we quote the work.
Chimney Brush and Rods
Sweeps creosote and debris from the flue and smoke chamber. Sized to the flue so it cleans the walls without damaging tile.
Angle Grinder with Diamond Blade
Cuts out failed firebrick and mortar joints cleanly. A diamond blade goes through refractory material without shattering the surrounding brick.
Masonry Trowel and Mortar Jointer
Sets new firebrick and strikes the joints. The jointer gives the finished joint the same profile as the original masonry.
Caulking Gun
Applies waterproofing sealant and flashing sealant. We use it at the roof line and on the brick after crown repairs.
Power Drill with Wire Brush
Cleans mortar joints before repointing and preps brick surfaces for waterproofing. Fast and consistent compared to hand brushing.
Drop Cloths
Seal the work area so dust and debris stay out of your living space. We lay them before any cutting starts.
Use cases
When Orange Homeowners Call Us
These examples show how the service framework adapts rather than forcing every call through one repair.

Chimney Leak Repair in Orange Hills
The homeowner had a ceiling stain that reappeared every time it rained hard. The crown had a hairline crack running across it, and the flashing at the roof line had pulled away from the brick. Water was running down the flue and into the attic. → We rebuilt the crown with chimney crown mix, reset and sealed the flashing, and waterproofed the brick. We also replaced the damaged chimney cap. Two winters later, no leak and no new stain. The job took one day.
Damper and Liner Replacement in Mabury Park
The damper would not close, so the house lost heat all winter. The flue liner had deteriorated to the point where gaps were visible on camera. The homeowner was burning with an unsafe flue and did not know it. → We replaced the damper and installed an insulated stainless steel liner sized to the firebox. Draft improved immediately and the homeowner reported the room held heat noticeably better. The job took two days.
Problems we solve
Fireplace Problems We Solve in Orange
Most fireplace calls we get in Orange come down to four failures: smoke where it should not be, water where it should not be, heat loss, and structural cracks. Here is what each one means and how we fix it.
Smoke rolling into the room on a cold start
We run a camera up the flue to find the restriction, then reline or parge the smoke chamber as needed. If the damper is the problem, we repair or replace it. A burn test confirms the draft before we leave.
Ceiling stain after heavy rain
We inspect the crown, flashing, and brick from the roof. Failed crown gets rebuilt with chimney crown mix, flashing gets reset and sealed, and the brick gets waterproofed. Most of these repairs finish in one day.
Damper will not close and heat escapes
We repair or replace the damper and make sure it seals. If the flue liner is also deteriorated, we reline it in the same visit. It is one of the cheapest fixes with the fastest payback.
Cracked firebrick and mortar joint failure
We cut out the failed firebrick and mortar, rebuild with new firebrick and refractory mortar, and repoint the joints. If the damage extends to the chimney exterior, we tuckpoint and waterproof it too.
Pricing process
What Fireplace Restoration Costs in Orange
$3,200 - $9,500 for a full restoration; $2,400 - $5,800 for relining alone
Scope of the rebuild
A damper replacement is a one-day job. A full firebox rebuild with new firebrick, a reline, and a crown rebuild takes three to five days. Labor and materials scale with the scope, and the camera inspection is what tells us which one you need.
Liner length and type
A stainless steel liner is priced by the foot, and taller chimneys cost more. Insulated liners cost more than uninsulated but hold heat better and draft more reliably. We size the liner to the firebox opening, not to a generic spec.
Masonry condition
If the brick around the firebox is sound, we rebuild the firebox only. If spalling has spread to the chimney breast, we tuckpoint and replace brick, which adds labor. Catching it early keeps this number down.
How much does fireplace restoration cost in Orange NJ?
Most fireplace restorations in Orange run $3,200 to $9,500 in 2026, depending on scope. A damper and crown repair sits at the low end. A full firebox rebuild with a stainless steel liner, new firebrick, and waterproofing lands at the top. Relining alone typically runs $2,400 to $5,800. We give you a fixed price after a camera inspection, so you are not guessing.
What is included in fireplace restoration in Orange New Jersey?
A full restoration includes firebox rebuild with firebrick and refractory mortar, flue relining with a stainless steel liner or clay flue tile, damper repair or replacement, crown rebuild, flashing reset, and waterproofing. We also tuckpoint failed mortar joints and install a chimney cap if yours is damaged. Sweeping and a burn test are included at the end. Cosmetic work like a new hearth stone is quoted separately.
How long does fireplace restoration take in Orange NJ?
A full restoration takes three to five working days. Day one is inspection and teardown. Days two and three cover the firebox rebuild and relining. Day four is crown, flashing, and waterproofing. Day five is the burn test and walkthrough. Smaller jobs, like a damper replacement or crown repair, finish in one day. We tell you the schedule before we start.
Can I restore my old fireplace in Orange New Jersey?
Yes, in almost every case. Original 1920s brick fireplaces in Old Towne Orange and the surrounding neighborhoods are rebuildable as long as the surrounding wall is sound. We cut out failed firebrick, repoint with refractory mortar, and reline the flue. The only time we recommend replacement is when structural cracks run through the chimney breast itself. A camera inspection tells us which side of that line you are on.
Ready when you are
Get Your Fireplace Restoration in Orange, New Jersey
We scope every job from a camera inspection and give you a fixed price before we start. Licensed, insured, and warrantied. Call (844) 803-5147 or book online and we will get you on the schedule.

Talk with the local team
Request Fireplace Restoration
Call us at (844) 803-5147 or email info@hardyzap.com. Our phone is answered 24/7 for emergencies, and we schedule regular appointments Monday through Friday. We serve Orange, New Jersey and the surrounding neighborhoods, and we'll tell you honestly what your chimney needs.



